Rick/Smith,
Often times when we have an attribute that can take either a range of values or discrete values we use the syntax "1setOf (integer | rangeOfInteger)".
> On Oct 21, 2019, at 8:10 AM, Yardumian, Rick via ipp <ipp at pwg.org> wrote:
>> Hi Smith,
>> Canon has one comment on the current IPP Job and Printer Extensions – Set 3 v2.0 specification
>> Relating to:
> > 1. Borderless adjustment setting
> > Section 6.2.3 media-overprint
>> Page 43 of:
>https://ftp.pwg.org/pub/pwg/ipp/wd/wd-ippjobprinterext3v20-20191003-rev.pdf> 6.8.9 media-overprint-supported (rangeOfInteger(0:MAX))
> <Feedback>
> “rangeOfInteger” does not work here. This should be “1setofInteger” because this is for discrete values specified by the printer.
>> Best regards,
> Rick
> From: ipp <ipp-bounces at pwg.org> On Behalf Of Kennedy, Smith (Wireless & Standards Architect) via ipp
> Sent: Thursday, October 03, 2019 10:07 PM
> To: PWG IPP WG Reflector <ipp at pwg.org>
> Subject: [IPP] Updated draft of IPP Job and Printer Extensions - Set 3 v2.0 posted
>> Greetings,
>> I've just posted an updated draft of IPP Job and Printer Extensions - Set 3 v2.0:
>>https://ftp.pwg.org/pub/pwg/ipp/wd/wd-ippjobprinterext3v20-20191003.pdf>https://ftp.pwg.org/pub/pwg/ipp/wd/wd-ippjobprinterext3v20-20191003.docx>https://ftp.pwg.org/pub/pwg/ipp/wd/wd-ippjobprinterext3v20-20191003-rev.pdf>https://ftp.pwg.org/pub/pwg/ipp/wd/wd-ippjobprinterext3v20-20191003-rev.docx>> Changes include:
> • Resolved all errata comments
> • Renamed "soft-proof-icc-profiles" to "print-color-mode-icc-profiles" but chose alternate member attribute names
> • Refactored tables for "printer-input-tray", "printer-output-tray" and "printer-supply" to make them easier to read and reference / cross-reference with RFC 3805, and spell checked all OID names to hopefully eliminate all typos that were in the old 5100.13
> • Added conformance tables to all section 6 subsections.
> • Created a new section 12 "Printer Resource Best Practices" from old section 14.4 and referenced that for HTTP and URI best practices
> • Refactored and updated the Conformance Requirements section
> • Added "eliminate-margins" to support the "Eliminate Upper and Lower Margins" and "Banner printing" use cases requested by Canon and HP
> • Added "media-overprint" to support the "Borderless adjustment setting" use case requested by Canon and HP
> • Enhanced the description for "print-quality-hints-supported"
> Cheers,
>> Smith
>> /**
> Smith Kennedy
> HP Inc.
> */
>> _______________________________________________
> ipp mailing list
>ipp at pwg.org>https://www.pwg.org/mailman/listinfo/ipp
_________________________________________________________
Michael Sweet, Senior Printing System Engineer