I've down loaded the .pdf for the .doc files as Peter requested for
tomorrow's telecon. I've also put all four in the proper place in the IPP
spec hierarchy as well under the new_JOBX arc (but I did not delete them
from the Semantic_Model sub-tree):
ftp://ftp.pwg.org/pub/pwg/ipp/new_JOBX/wd-ippjobx10-20030702.pdf
<ftp://ftp.pwg.org/pub/pwg/ipp/new_JOBX/wd-ippjobx10-20030702.pdf>
ftp://ftp.pwg.org/pub/pwg/ipp/new_JOBX/wd-ippjobx10-20030702.doc
<ftp://ftp.pwg.org/pub/pwg/ipp/new_JOBX/wd-ippjobx10-20030702.doc>
ftp://ftp.pwg.org/pub/pwg/ipp/new_JOBX/wd-ippjobx10-20030702-rev.pdf
<ftp://ftp.pwg.org/pub/pwg/ipp/new_JOBX/wd-ippjobx10-20030702-rev.pdf>
ftp://ftp.pwg.org/pub/pwg/ipp/new_JOBX/wd-ippjobx10-20030702-rev.doc
<ftp://ftp.pwg.org/pub/pwg/ipp/new_JOBX/wd-ippjobx10-20030702-rev.doc>
<ftp://ftp.pwg.org/pub/pwg/ipp/new_JOBX/wd-ippjobx10-20030702.doc>
Tom
-----Original Message-----
From: Zehler, Peter [mailto:PZehler at crt.xerox.com]
Sent: Wednesday, July 02, 2003 08:16
To: PWG Semantic Model WG (sm at pwg.org)
Cc: 'Claudia Alimpich'; IPP Discussion List (IPP at pwg.org);
printing-jobticket at freestandards.org; printing-driver at freestandards.org
Subject: SM> Semantic Model (JobX) teleconference
All,
Thursday July 10th at 1pm EDT is the Semantic Model teleconference. This
week's Teleconference will be dedicated to IPP JobX. The document is
available on the PWG server at
<ftp://ftp.pwg.org/pub/pwg/Semantic-Model/wd-ippjobx10-20030702.doc>
ftp://ftp.pwg.org/pub/pwg/Semantic-Model/wd-ippjobx10-20030702.doc
(If someone could convert this to PDF I would appreciate it. I haven't
found my copy of distiller to put on my new system yet.)
The teleconference is 2 hours long. It will be run using phone and Webex.
Anyone that does not yet have Webex installed should do that before
Thursday. Information for the phone and Webex are included below. NOTE:
New Dial in number and passcode
The agenda for the Semantic Model teleconference is:
1) Discuss the print-quality issue (see included notes below)
2) Discuss the document-xxx-supplied changes in JobX
3) Discuss the output-device resolution
Pete
PS: Bob let me know if there is a problem hosting Webex.
________________________________________________
Dial in Info:
Phone Number:(877) 707-6056
(Phone Number for Xerox Employees: 8*594-0077)
PARTICIPANT PASSCODE: 437874#
________________________________________________
webex info:
We will also use an on line tool called webex,
if you have not used this before, setup up by
following the First Time Users instructions.
Do this in advance of the meeting.
-------------------------
FIRST TIME USERS
-------------------------
For fully interactive meetings, including the ability
to present your documents and applications, a one-time
setup takes less than 10 minutes. Click this URL to set up now:
<http://hp.webex.com> http://hp.webex.com
Then click New User.
-------------------------
On Thursday use:
<https://hp.webex.com/join/> https://hp.webex.com/join/
Then click join unlisted meeting.
Use the info below:
-------------------------
Webex MEETING SUMMARY
-------------------------
Topic: PWG Semantic Model
Date: Thursday, July 10, 2003
Time: 10:00 am, Pacific Daylight Time (GMT -07:00, San Jose)
Meeting number: 21366675
Meeting password: pwg_sm1!
Host:
Bob Taylor (HP)
___________________________________________________
BM__MailAutoSigPeter Zehler
XEROX
Xerox Innovation Group
Email: PZehler at crt.xerox.com
Voice: (585) 265-8755
FAX: (585) 422-7961
US Mail: Peter Zehler
Xerox Corp.
800 Phillips Rd.
M/S 128-25E
Webster NY, 14580-9701
Print Quality Issue:
Last Tuesday during the PWG/FSG meeting in Portland we had a discussion
about the IPP print-quality attribute and FSG's desire to add two new
values, "economy" and "fine", where "economy" is lower than "draft" and
"fine" is higher than "high". After some discussion we all pretty much
decided that it is not possible to add these new values to the already
existing "draft", "normal", and "high" values because of the current
definitions of the existing values (high is defined as the highest quality
and draft is defined as the lowest quality). It also seemed like what FSG
wanted was a way to specify print optimization and not additional levels of
print quality.
The FSG working group met today, and based on the input from last Tuesday's
meeting, we would like to propose the addition of a new attribute, called
print-optimize, that is defined as follows:
print-optimize (type2 keyword)
This attribute refines the value specified by the print-quality
attribute.
The standard keyword values are:
'image': optimize for image clarity
'photo': optimize for photo clarity
'text': optimize for text clarity
'text-and-image': optimize for both text and image clarity
'save-toner': optimize for minimal toner usage
'speed': optimize for printing speed
We would appreciate your feedback on this proposal including suggestions for
additional values.
If this proposal looks good, we would like to propose that it be included in
the JobX Spec. If the print-optimize attribute is approved by PWG by the end
of August, then we can propose that it be added to the JDF 1.2 Spec that is
being finalized in early September.
Thank you for your time and feedback.
Claudia Alimpich
IBM Printing Systems Division
Boulder CO
303-924-4418
alimpich at us.ibm.com
Response to Print Quality Issue:
I understand the desire to avoid violating the semantics of the IPP
attribute - but adding these enumerations to print-quality does not feel as
objectionable to me as splitting a single semantic concept into two
different attributes. If this is the precedent we take for extending the
semantic model, I'm worried that we'll end up with an increasingly confusing
and complex. I would rather we take the minor hit and fix the high & draft
definitions in the semantic model than create another ~equivalent attribute
with a whole bunch of special semantic rules (e.g. - what should the service
do if print-quality=high and print-optimize=save-toner?).
bt
---------------------------------------------------
Bob Taylor
Senior Architect
IPG Strategic Technology Development
Hewlett-Packard Co.
<mailto:bobt at hp.com> mailto:bobt at hp.com
phone: 360.212.2625/T212.2625
fax: 208.730-5111
---------------------------------------------------
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.pwg.org/archives/ipp/attachments/20030709/eaa72de2/attachment-0001.html