Hi folks,
Note that the '.txt' version was stored using a binary transfer
(leaving the Windows/DOS carriage returns in the file).
So if you retrieve it from a UNIX/POSIX system you'll get some
unwanted CR's, even in binary mode.
If you retrieve it to a Windows/DOS system, remember to set
BINARY transfer mode first, to avoid DOUBLING the carriage
returns (double-spacing the text lines).
The Internet-Drafts editor will probably clean up the carriage
returns as a matter of course on the 'ftp.ietf.org' repository.
Cheers,
- Ira McDonald, consulting architect at Sharp and Xerox
High North Inc
-----Original Message-----
From: Bergman, Ron [mailto:Ron.Bergman@Hitachi-hkis.com]
Sent: Thursday, May 31, 2001 1:26 PM
To: 'pmp@pwg.org'; 'pwg-announce@pwg.org'
Subject: RE: PMP> New Printer MIB Submitted to the IETF
The text version is also now at the PWG site.
Ron
-----Original Message-----
From: Bergman, Ron [mailto:Ron.Bergman@hitachi-hkis.com]
Sent: Thursday, May 31, 2001 10:22 AM
To: 'pmp@pwg.org'; 'pwg-announce@pwg.org'
Subject: PMP> New Printer MIB Submitted to the IETF
Version 07 of the Printer MIB has been submitted to the IETF. It should be
available tomorrow or early next week. A DOC and PDF file is available on
the PWG site at:
ftp://ftp.pwg.org/pub/pwg/pmp/drafts/draft-ietf-printmib-mib-info-07.pdf
and .doc
For some reason the PWG site sould not accept the .txt version, so you can
either wait until it is available from the IETF or send me a message and I
will email it.
Ron Bergman
Hitachi Koki Imaging Solutions
This archive was generated by hypermail 2b29 : Fri Jun 01 2001 - 11:02:51 EDT