Hi,
I've just posted a Stable draft of the PWG Imaging System Power MIB, ready
for WIMS WG last call:
ftp://ftp.pwg.org/pub/pwg/wims/wd/wd-wimspowermib10-20100926.mib
- full ASN.1 source with compliance statements, defaults, references, etc.
ftp://ftp.pwg.org/pub/pwg/wims/wd/wd-wimspowermib10-20100926-mib.pdf
- full ASN.1 source with line numbers and color highlighting
ftp://ftp.pwg.org/pub/pwg/wims/wd/wd-wimspowermib10-20100926.pdf / doc
- full MS Word document with all sections completed
ftp://ftp.pwg.org/pub/pwg/wims/wd/wd-wimspowermib10-20100926-rev.pdf / doc
- full MS Word document with redlines and line numbers
This draft addresses all the comments from the Samsung prototypes and the
WIMS WG review last week.
This document is technically aligned with PWG Power Management Model.
Cheers,
- Ira
-------------------
***Changes made to create 26 September 2010 version (Stable Draft)*
Editorial – Kept document status at Stable
Editorial – Revised section 1.4 Power State Transition Notifications to
change
“RECOMMENDED” to “recommended”, per WIMS WG review
Editorial – Revised sections 6.1 and 6.2 (conformance) to add “if these
components are present” for Scanner and Marker recommendations, per WIMS
WG review
Technical – Revised powGeneralMaxLogRecords to change default to 20 (but
keep minimum at 10), to accommodate logging for Subunits (e.g., Scanner and
Marker), per MPSA feedback
Technical – Revised powLogPowerState to reduce MUST to SHOULD for successive
entries for the same component with different states (i.e., a power
transition), per WIMS
WG review
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pwg.org/pipermail/wims/attachments/20100926/5782033a/attachment-0001.html>