Hi,
I've just posted a Stable draft of the PWG Power Management Model:
ftp://ftp.pwg.org/pub/pwg/wims/wd/wd-wimspower10-20100922.pdf / doc
- clean copy with line numbers
ftp://ftp.pwg.org/pub/pwg/wims/wd/wd-wimspower10-20100922-rev.pdf / doc
- redlines with line numbers
This draft addresses all the comments from the Samsung prototypes and the
August PWG F2F.
This document is technically aligned with PWG Imaging System Power MIB.
Comments?
Cheers,
- Ira
--------------------------
***C Changes made to create 22 September 2010 version (Stable Draft)*
Editorial – Changed document status to Stable, per August PWG F2F
Technical – Added new section 3.2.5 Automatic Policy Use Case (for
device-written
power management policies per MPSA feedback) but did NOT add any such
feature
to the model, per August PWG F2F
Technical – Revised section 5.1 Power General Group and section 5.6.1
(examples)
to add MaxCounterRecords, MaxMeterRecords, and CanRequestPowerStates (list
of
all supported stable and transitional power state), per August PWG F2F
Technical – Revised section 5.3 Power Log Group and section 5.3.2 to clarify
that only
state transitions are allowed (i.e., successive log records for the same
component MUST
NOT have the same state), per August PWG F2F
Technical – Revised section 5.5 Power Meter Group to make RECOMMENDED, per
August PWG F2F
Technical – Revised section 6.1 Power Support Group and section 6.3.1
(examples) to
add PowerPeakWatts (as distinguished from PowerActiveWatts), per August PWG
F2F
Technical – Added new section 5.7 Power State Notifications to clarify that
power state
transition notifications SHOULD be implemented using the printerV2Alert SNMP
trap
(RFC 3805), IPP Event Notifications (RFC 3995), Web Services interfaces, and
any other
support system management protocols, per August PWG F2F
Technical – Revised section 6.1 Power Support Group and section 6.1.1
PowerState to
clarify that only *stable* power states can be listed, per August PWG F2F
Technical – Revised section 6.2 Power Transition Group, section 6.2.1
StartPowerState,
and section 6.2.2 EndPowerState to clarify that only *stable* power states
can be listed,
per August PWG F2F
Technical – Revised section 6.3 (examples) to map Power Capabilities to
SystemStatus
group in XML Schema, per August PWG F2F and subsequent MFD WG discussion
Technical – Revised section 7.2 Power Timeout Group to make RECOMMENDED, per
August PWG F2F
Technical – Added new section 9.8 printer-state-reasons in IANA IPP Registry
(to
complement the updates to PrtAlertCodeTC defined in section 9.7)
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.pwg.org/pipermail/wims/attachments/20100922/7f396189/attachment-0001.html>