Hi,
[For review next Tuesday 8 December during PWG F2F in Austin]
I've just posted a Prototype draft of the PWG Power Management Model:
ftp://ftp.pwg.org/pub/pwg/wims/wd/wd-wimspower10-20091204.pdf / doc
- clean copy
ftp://ftp.pwg.org/pub/pwg/wims/wd/wd-wimspower10-20091204-rev.pdf / doc
- redlines
This draft is technically aligned with the Power MIB.
Comments?
Cheers,
- Ira
--------------------------------------------
Changes made to create 4 December 2009 version (Prototype Draft)
Editorial – Kept document status as Prototype
Editorial – Corrected definition of Standby in section
2.4.2, per Bill Wagner
Editorial – Deleted ISSUE comments in section 3.2,
now closed
Editorial – Renamed power state Off (ambiguous with
Off Mode) to OffSoft (to distinguish from OffHard) in
section 2.4.2 DMTF CIM Power States and section 9.1
PowerStateWKV, consistent with DMTF CIM, per Bill
Wagner
Editorial – Renamed PowerComponentId to
PowerComponentReferenceId in section 5.2 Power
Monitor, to clarify usage (found in SNMP MIB
development)
Editorial – Renamed PowerUsageWatts (ambiguous
with power gauges) to PowerNominalWatts (per vendor)
in section 6.1 Power Support, to clarify usage
Technical – Added section 9.7 PrtAlertCodeTC in
IANA Printer MIB, for ‘standby(508)’, ‘suspend(509)’,
and ‘hibernate(510)’, per WIMS WG discussion
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.