I see I made a boo-boo when converting to use the IEEE-ISTO Template (which
I stole from the PWG Media standard).
I didn't change the IEEE-ISTO number in the upper right hand corner of the
first page.
It currently says 5101.1 (which is the PWG Media standard!).
Its done as an MS-WORD Header, so if you don't look at the Headers and
Footers (which you don't see in Normal Mode), you can forget to change the
header to the correct number, which is the error that I made.
It should have said 5100.5 (which is what is said everywhere else in the
document).
We should also put the word Draft and D0.4 in the header as well.
So it should have said something like the following in the upper right
corner:
Draft 0.4 for IEEE-ISTO 5100.5-2002
Sorry about that,
Tom
-----Original Message-----
From: Zehler, Peter [mailto:PZehler at crt.xerox.com]
Sent: Thursday, October 17, 2002 06:02
To: PWG Semantic Model WG (E-mail); IPP Discussion List (E-mail)
Subject: SM> Semantic Model review of Document Object
All,
The PWG Semantic Model Work Group will host the review of the Document
Object Specification in their October 24th telecon. This review is in
preparation for the face to face review in New Orleans during the afternoon
of the Semantic Model day. I'm sending this note out to allow for adequate
time for people to review the document. Attached below is Tom Hasting's
information on the document and the teleconference information for the 24th.
A detailed agenda will be sent out early next week. I expect to discuss the
18 issues Tom has called out. Please send any comments you may have on the
document to the Semantic Model mail list (sm at pwg.org)
To Subscribe to the Semantic Model Mail List: Send e-mail to
majordomo at pwg.org, put SUBSCRIBE or SUBSCRIBE SM in the body (not subject).
Pete
Peter Zehler
XEROX
Xerox Architecture Center
Email: PZehler at crt.xerox.com
Voice: (585) 265-8755
FAX: (585) 265-8871
US Mail: Peter Zehler
Xerox Corp.
800 Phillips Rd.
M/S 128-30E
Webster NY, 14580-9701
snip...