The SMB and AppleTalk names were admittedly thrown in just for good measure
-- but I would definitely like to see the IPP URI in the MIB. Maybe the
queue name object could be renamed, as you suggest?
Other than IPP, the other port types we would expect to support with this
would be NPA (IEEE 1284) and IPDS, but I'll need to verify with our
engineering team whether we need any additional info for those port types.
Yes, there are devices that do restrict source ports. Some colour
controller manufacturers come to mind!
For the Fiery example, there are hold, print and direct queues, with
different defined behaviours. Specifically, documents sent to the hold
queue will not print until explicitly released. The print queue spools
first, then prints, while the direct queue prints immediately without
intermediate spooling. (Our secure printing software can provide
conceptually similar behaviour for specified print queues on a print
server.)
I would expect some production devices to have similar queue choices
available -- Ron, is that true for the Ricoh production systems?
Tom
-----Original Message-----
From: Bergman, Ron [mailto:Ron.Bergman at rpsa.ricoh.com]
Sent: Monday 17 January 2005 21:10
To: Haapanen, Tom; pmp at pwg.org
Subject: RE: PMP> Draft MIB comments
Hi Tom,
Good questions. See my responses in-line.
Ron
-----Original Message-----
From: pmp-owner at pwg.org [mailto:pmp-owner at pwg.org]On Behalf Of Haapanen, Tom
Sent: Monday, January 17, 2005 5:39 PM
To: pmp at pwg.org
Subject: PMP> Draft MIB comments
Everyone,
Here is my initial set of comments on the draft Print Port Monitor MIB.
This is based largely on our experience of developing port monitors (and
equivalent modules on other platforms) to communicate with a myriad of
devices.
So, in no particular order ...
- Shouldn't the ppmPortTable include a URI object for IPP printers?
Otherwise there is no way to know how to connect to an IPP device. What
about SMB share names or AppleTalk names?
<Ron> The scope was limited to LPR and TCP Sockets since those were the
protocols in Microsoft's request. Although, in our discussions it
was agreed that it should be open to all protocols. IPP could be
reported in the ppmPortProtocolType and the ppmPortProtocolPortNumber
containing the port used. In discussions, Microsoft did not see a
a need so it was not described as a possibility.
The SMB and AppleTalk names are normally broadcast so I am not sure
why they would be needed, especially since they are now being used
less and less. Using the ppmPortLprQueueName (with a rename) would
allow support of these protocols. If you feel strongly about these
a simple modification and rewrite of the descriptions would provide
the support.
- For LPR devices, I would like to see an object that specifies whether the
device accept source ports outside the RFC range. Most devices, but not
all, do today, and this can really help throughput with small documents.
<Ron> Are there printers that do not support any source port? If no,
this would be a good additional MIB object.
- What would be the expected behaviour if there are multiple ports of the
same type? For example, Fiery controllers typically have three LPR queues
-- would it not be beneficial to be able to publish all three, and to
describe their behaviour?
<Ron> There is no limit to the number of ports or queues that can be
reported in the MIB. It is an SNMP table and supports large
number of entries. I assume the Fiery controller LPR queues
each have a unique name.
Tom