RFC 1759 does not compile after being stripped (using mstrip).
You could try either of the .mib files which are RFC 1759 stripped and are
located at:
ftp://ftp.pwg.org/pub/pwg/pmp/mibs/Printer-MIBv1.mibftp://ftp.pwg.org/pub/pwg/pmp/mibs/Printer-MIB.mib
Or you could try the newer Internet-Draft that is intended to supersede RFC
1759 which is available at:
-----Original Message-----
From: lpyoung at lexmark.com [mailto:lpyoung at lexmark.com]
Sent: Thursday, January 28, 1999 12:27
To: pmp at pwg.org
Subject: PMP> Latest Printer MIB internet draft
When I did not hear of any changes in the latest Printer MIB
document and in anticipation of publishing the Printer MIB as
a Draft Standard, I sent the document on to the Internet Draft
editor. The Internet Draft document is at:
ftp://ftp.pwg.org/pub/pwg/pmp/drafts/draft-ietf-printmib-mib-info-04.txt
The only changes in the document versus the last one I published
is the date on the document and the I-D expiration date.
Regards,
Lloyd
------------------------------------------------------------
Lloyd Young Lexmark International, Inc.
Senior Program Manager Dept. C14L/Bldg. 035-3
Strategic Alliances 740 New Circle Road NW
internet: lpyoung at lexmark.com Lexington, KY 40550
Phone: (606) 232-5150 Fax: (606) 232-6740
-----Original Message-----
From: OGrant [mailto:OGrant at PEC.com]
Sent: Tuesday, March 16, 1999 14:22
To: 'pmp at pwg.org'
Subject: PMP> difficulty in loading rfc1759 mib
I'm currently using Tivoli's Netview 5.1 for NT, and received the following
message when attempting to load the above mib:
Line 14: Error defining object: found 'MODULE-IDENTITY'
Expected one of the following:
OBJECT IDENTIFIER
OBJECT-TYPE
TRAP-TYPE
::=
I confirmed that rfc's 1213 and 1514 were both loaded prior to loading the
above; however, the install still failed - any suggestions?
Thanks much,
Oliver M. Grant
Performance Engineering Corp.