I have copied version 0.3 of the IPP "-actual" attributes spec to the PWG
ftp site:
ftp://ftp.pwg.org/pub/pwg/ipp/new_ACT/pwg-ipp-actual-attrs-v03-021216.pdfftp://ftp.pwg.org/pub/pwg/ipp/new_ACT/pwg-ipp-actual-attrs-v03-021216.docftp://ftp.pwg.org/pub/pwg/ipp/new_ACT/pwg-ipp-actual-attrs-v03-021216-rev.pdfftp://ftp.pwg.org/pub/pwg/ipp/new_ACT/pwg-ipp-actual-attrs-v03-021216-rev.doc
This version includes the decisions made on the 12/12/02 Semantic Model
teleconference.
This version is intended to be a candidate for a last call to begin in a
few weeks.
It was agreed that all discussion of this spec will occur on the Semantic
Model mailing list. However, I copied this announcement to the IPP mailing
list so the existence of the spec was known.
The abstract:
This document defines an extension to the Internet Printing Protocol/1.0
(IPP/1.0) [RFC2566, RFC2565] & IPP/1.1 [RFC2911, RFC2910] for the OPTIONAL
"-actual" set of Job Description attributes that correspond to Job Template
attributes defined in IPP. These "-actual" attributes allow the client to
determine the true results of a print job regardless of what was specified
in the Create-Job or Print-Job operation.
Note that it was discussed on the telecon that I would replace section 2.1,
the Conformance Terminolgy section, with a better version that Tom Hastings
and Ira McDonald have been working on. The new improved version of that
section is not ready yet, so I'm going to put out a 0.3 version without
that change, then possibly pick up that change in the last call version.
Dennis Carney
IBM Printing Systems